E-Lins H695 Series - Page 10

H695 Series Router User Manual 
E‐LinsTechnologyCo.,Limited
Add:Bld22.,LongxiGarden,NonglinRD.,FutianDistrict,Shenzhen,518000,China
Tel:+86‐0755‐81220758Fax:+86‐755‐83700465E‐mail:sales@e‐lins.comwww.e‐lins.com
Step 1: Ensure that the computer is on the same network address range as the Router and make it as
your computer’s default gateway and DNS server.
ConsultyouroperatingsoftwareusermanualtodeterminehowtochangetheIPaddressontheEthernetportofthe
computerandthedefaultgatewayaddress.IntheexamplebelowtheIPaddressofthePChasbeensetto192.168.0.2
－192.168.0.253andthedefaultgatewayisthe
defaultaddressofthecellularRouter(192.168.0.254)andPrimaryDNS
as192.168.0.254
For Windows XP the sequence is:
START >>Control Panel >> Network Connections >>Right-Click on Local Area Connection >> Properties
>> Internet Protocol

Change the computer’s IP address, default gateway and DNS server and then click OK.
It may take a minute or two for the computer to be allocated the new IP address. In some cases, a reboot may be
required

Step 2: To test that there is connectivity between the computer and the Axon, you can ping the Axon
using the ping command at the command prompt. To get to the command prompt in Windows XP, use:
START>>RUN>>cmd
Thepingcommandisenteredas
follows:
Ifsuccessfulyoushouldseesomepingstatisticslikethefollowingexample:
z 1) If having appeared with command: "Request timed out." That indicate PC and H695 cellular
Router are not in the same net section. Please run “IPCONFIG/ALL” under the command
model.
Please check the two IP are in the same set. If they are, but still ping successfully, it is possibly wrong in PC ARP.
Recommend run “ARP –D” first. Attention: If appears former error in setting more than one H685 cellular Router ,
becausethesamedefaultIP
butdifferentMAR,thenitmustrun“PING”after“ARP–D”.
z 2) It indicates that no real connect between PC and H685 cellular Router when come out
“Destination host unreachable”. Please check or change the cable after setting the 10M Half
model of the Ethernet card.
z 3) If still PING blocks up, please whether or not can lead to by PING between your PC and other
PC, and checks up if PC has the software such as fire wall at the same time. If still PING