Changing switch type for safety beam input:-
Default:- Normally open
Action Response
2 beeps
After confirmation beeps Continuous beep
Continuous beep off
To change again without leav ing programming, repeat from point 2.
Remov e program jumper or continue to another programming option
1. Program jumper on
2. Dip-switch 1 and 2 on
3. Press and release Set button
Beeps confirm change
1 beep = N/C
2 beeps = N/O (Default)
4. Dip-switch 1 and 2 off
To Next Page
Loading...
