Eagle 2000 BWS - Page 30

- 30 -
5.1 Troubleshooting Guide
Problem Possible Causes Solution
Carriage
does not run
 Check to see if the machine is plugged in.
 Check carriage speed knob is at minimum
position – if so turn carriage speed knob to a
higher setting.
 Check to see if the chain is broken or
disconnected.
 Carriage sliding block is jammed – realign slide
block.
 Plug machine into adequate
power 110 Volt outlet.
 Replace chain or reinstall chain
/ remove any debris.
 Loosen slider blocks to realign
and lubricate with a dry lube.
 Adjust speed potentiometer to
correct speed.
Film breaks
 Speed is not set well between load force and
turntable speed – adjust the settings.
 Check for cuts in film.
 Move dancer bar without film to see if motor
turned on.
 Pre-stretch chain is broken or jammed –
reinstall chain or refasten chain wheel.
 Replace roll of film.
 Faulty drive / look for rdy on
display. May need replaced.
 Replace chain or reinstall chain
and tighten all hardware.
 Adjust speed potentiometer to
correct speed.
Scale does
not work
 Is the machine level.
 Are all of the leveling feet in the proper place?
 Start by placing the machine on
a flat surface and using a level.
 Using the leveling feet supplied
and screw into load cell.
Notes: