Need help?Do you have a question about the EasyIO 30P and is the answer not in the manual?
Details power consumption ratings for EasyIO products, including EasyIO-30P and EasyIO-DEM-5.
Lists supported protocols: BACnet, Modbus, and Sedona.
Default credentials are Username: admin, Password: 1234.
Default IP is 192.168.10.10 with subnet mask 255.255.255.0.
Guide to changing IP via web browser: Main > Network tab.
Outlines methods: Hyper terminal (Boot Loader Mode via Ethernet/Serial), EasyIO firmware tool.
Refers to EasyIO Basic 01 - Firmware Flashing User Guide.
Connects via Ethernet or Serial COM; refers to firmware flashing guide.
Default IP is 192.168.10.10, separate from web browser IP; credentials differ.
Connects via serial COM; RS-485 converter may be needed.
Programming is via Niagara Workbench with Sedona Workbench; different from BACnet/Modbus.
Supports BACnet IP/Ethernet/MS/TP, Modbus TCP/RTU, and Modbus Master/Salve.
Default credentials are Username: admin, Password: 1234, Web Port: 80.
Change via Sedona Workbench (Niagara Workbench): Go to Sedona/App/Service/Users.
Steps: Open Niagara Workbench, File > Open > Open Sedona, enter credentials.
Clear via web browser: Sedona > Sedona Tab, enter magic number to reinstall VM.
Details power consumption ratings for EasyIO products, including EasyIO-30P and EasyIO-DEM-5.
Lists supported protocols: BACnet, Modbus, and Sedona.
Default credentials are Username: admin, Password: 1234.
Default IP is 192.168.10.10 with subnet mask 255.255.255.0.
Guide to changing IP via web browser: Main > Network tab.
Outlines methods: Hyper terminal (Boot Loader Mode via Ethernet/Serial), EasyIO firmware tool.
Refers to EasyIO Basic 01 - Firmware Flashing User Guide.
Connects via Ethernet or Serial COM; refers to firmware flashing guide.
Default IP is 192.168.10.10, separate from web browser IP; credentials differ.
Connects via serial COM; RS-485 converter may be needed.
Programming is via Niagara Workbench with Sedona Workbench; different from BACnet/Modbus.
Supports BACnet IP/Ethernet/MS/TP, Modbus TCP/RTU, and Modbus Master/Salve.
Default credentials are Username: admin, Password: 1234, Web Port: 80.
Change via Sedona Workbench (Niagara Workbench): Go to Sedona/App/Service/Users.
Steps: Open Niagara Workbench, File > Open > Open Sedona, enter credentials.
Clear via web browser: Sedona > Sedona Tab, enter magic number to reinstall VM.
General| Brand | EasyIO |
|---|---|
| Model | 30P |
| Category | I/O Systems |
| Language | English |
To Next Page