Installation
Eaton 9135 5000/6000 VA UPS User’s Guide 164201726—Rev 4 www.eaton.com/powerquality 16
Connecting the UPS Internal Battery
To ensure proper battery operation:
1. Verify that the UPS is off and unplugged.
2. Remove the two screws from the battery switch (see Figure 2).
Figure 2. Removing the Battery Switch Screws
3. Slide the battery connector so that you can read Connected (see Figure 3).
4. Reinstall the two screws removed in Step 2.
5. Continue to the following section, ”UPS Setup.”
Figure 3. Connecting the Internal Battery Connector
Two
Screws
Battery Switch
Two
Screws
Battery Switch
To Next Page
Loading...
