Installation
Eaton 9135 5000/6000 VA UPS User’s Guide 164201726—Rev 4 www.eaton.com/powerquality 22
The setup varies depending on the number of cabinets you are installing:
1. Assemble the UPS pedestals (see Figure 11).
Figure 11. Assembling the UPS Pedestals
2. For one cabinet, the pedestals must be installed. Continue to Step 3.
For two or more cabinets, the pedestal extenders and the joining brackets must be installed. Proceed to
Step 6.
3. Carefully position the cabinet upright with the UPS indicators at the top and place in the pedestals (see
Figure 12).
4. Adjust the pedestals to the size of the UPS and secure the pedestals with the captive screws.
Figure 12. Tower Position with One Cabinet
5. Continue to the following section, “Installing the UPS.”
6. Install pedestal extenders for each additional cabinet:
NOTE Always keep 150 mm free space behind the UPS rear panel. The distance between
the tower stands should be 450 mm.
UPS Indicators
150 mm
(6”)
450 mm
(17.7”)
To Next Page
Loading...
