Installation
Eaton 9135 5000/6000 VA UPS User’s Guide 164201726—Rev 4 www.eaton.com/powerquality 25
Figure 17. UPS Installation with Three EBMs
4. If you plan to install power management software, connect your computer to the USB port or RS-232
communication port. For RS-232, use only the serial cable supplied in the accessory kit. For more
information about communication options, see Chapter 5, “Additional Features” on page 38.
Figure 18. Installing the RS-232 Serial Cable
5. If you are installing a remote power-off (RPO) switch, see the following section, “RPO Installation,” to
install the switch before powering on the UPS.
6. Continue to “UPS Electrical Connections” on page 26.
EBM
Communication
Cable
EBM Cable
EBM Battery
Connectors
Battery Circuit
Breaker
RS-232 Communication Port
RS-232 Communication Cable
To Next Page
Loading...
