Eaton 93PS - Steps to Install the UPS

5.2 Steps to install the UPS
Power and control wiring are routed through the rear of the cabinet with
connections made to easily accessible terminals, see Figure 16: Gland plate and
connector locations in the 15-20 kW standard and C-model frames and Figure
17: Gland plate and connector locations in the 30-40 kW frame.
To install and connect the power cabling of the external battery to the UPS, see
Section 5.3 Battery system installation.
Figure 16: Gland plate and connector locations in the 15-20 kW standard and C-
model frames
1. Connectors 2. Gland plate
Figure 17: Gland plate and connector locations in the 30-40 kW frame
1. Connectors 2. Gland plate
© Eaton Corporation plc 2020. All rights reserved. Revision: 006 Document ID: P-164000493 61 (126)
Eaton 91PS/93PS UPS 8–40 kW User’s and Installation Guide