Setting Description
Clock Change the date and time, change the clock format or enable/disable
NTP clock setup.
GSM GSM modem.
Call Service Send automatic e-mail to the service center in case of a failure.
Signal Input Select signal input name and function or change contact polarity.
Relay Outputs Configure the relay outputs.
Battery test Change the power level and duration for battery test.
Bypass Limits Change the bypass voltage or bypass frequency.
Screen Saver
Timeout
Change the screen saver timeout.
Meters Change the meters format.
Lamp Test Enable the lamp test.
HMI backlight Adjust the backlight brightness.
Control P/W
level 1
Change the level 1 password, or remove the password on level 1. The
default value is 1111.
Control P/W
level 2
Change the level 2 password. The default value is 1010.
Reset statistics Reset all statistics.
Minimum
required kVa
Change the minimum required kVa.
7.3 Signing in
If the level 1 password is enabled, you need to sign in.
1. Press the lock icon in the top right corner of the screen.
2. Type in your password and press OK.
You are signed in.
3. Press Continue to return to the previous screen.
You have 3 attempts to type in the password. If an incorrect password is given
more than 3 times, you need to wait for 30 minutes before trying again.
© Eaton Corporation plc 2020. All rights reserved. Revision: 006 Document ID: P-164000493 94 (126)
Eaton 91PS/93PS UPS 8–40 kW User’s and Installation Guide
To Next Page
Loading...
