-37-
11. Communication Port
On the rear panel of the UPS (see Appendix), RS232 connector is standard,
Slot for optional connectivity cards are optional.
11.1 RS-232 Communication Ports
To establish communication between the UPS and a computer by use an
RS-232 communication cable.
11.2 AS400 Interface (Optional)
It owns isolated dry contact relay outputs for UPS status: such as
Mains/Utility failure, Battery low, UPS alarm/OK, or on Bypass and so on.
To see more detail about the interface definitions please check the AS400
user manual.
11.3 CMC Interface (Optional)
It provides connection to Modbus protocol with standard RS485 signal.
To see more detail please check the CMC user manual.
11.4 NMC Interface (Optional)
NMC (Network Management Card) allows the UPS to communicate in a
variety of networking environments and with different types of devices. NMC
achieves a remote management for the UPS through internet/intranet.
Please contact your local dealer for further information. To see more detail
please check the NMC user manual
To Next Page
Loading...
Need help?
General
