What does it mean when the battery fault LED is on and Eaton 9PX 5000 beeps continuously?
This indicates that the battery test failed due to bad or disconnected batteries, or the battery minimum voltage has been reached in ABM cycling mode. Verify that all batteries are properly connected. Start a new battery test; if the condition persists, contact your service representative.
General| Power Rating | 5000 VA / 4500 W |
|---|---|
| Dimensions (H x W x D) | 3.5 x 17.5 x 21.3 in |
| Weight | 103 lbs |
| Form Factor | Rack/Tower |
| Warranty | 2 years |
| Input Voltage | 200-240 VAC |
| Output Voltage | 200/208/220/230/240 VAC |
| Output Frequency | 50/60 Hz |
| Battery Type | Sealed lead-acid battery |
| Communication | USB |
| Runtime at Half Load | Approx. 10-15 minutes (varies by battery configuration) |
| Topology | Double Conversion Online |
| Typical Backup Time | approximately 15 minutes at half load |
Details precautions for handling personnel and avoiding electrical hazards.
Outlines installation and operational safety guidelines for the UPS unit.
Covers handling, lifting, and battery replacement safety measures for the unit.
Explains how to connect Extended Battery Modules (EBMs) to the UPS.
Provides instructions for mounting the UPS in a 19-inch rack.
Specifies upstream protection and cable cross-section requirements.
Details the procedure for connecting input and output power cables by qualified personnel.
Guides on how to safely start up and shut down the UPS unit.
Describes the UPS's Online, Battery, Bypass, and Standby operating modes.
Explains automatic battery tests, low battery warnings, and deep discharge protection.
Describes the feature for remotely shutting down the UPS and load.
Advises on when to replace UPS batteries based on screen prompts.
Explains the procedures and precautions for replacing UPS batteries.
Presents a chart of common UPS alarms, their causes, and recommended actions.
To Next Page
