To Next PageTo Next PageWhat to do if no battery LED is on and my Eaton 9PX 2200 GRT UPS beeps continuously?
If no battery LED is on and the Eaton UPS beeps continuously, verify that all batteries are properly connected. If the condition persists, contact your service representative. The batteries are disconnected.
What to do if the Power overload LED is on and the Eaton 9PX 2200 GRT beeps continuously?
If the Eaton UPS's power requirements exceed its capacity, remove some equipment from the UPS. The UPS will continue to operate, but it might switch to Bypass mode or shut down if the load increases. The alarm will reset once the condition is no longer active.
Why is the battery mode LED on and my Eaton UPS beeping every 10 seconds?
When the battery mode LED is on and the Eaton UPS beeps every 10 seconds, it indicates a utility failure, and the UPS is running on battery power. Prepare your equipment for shutdown.
What does it mean when the bypass mode LED is on for my Eaton 9PX 2200 GRT UPS?
If the bypass mode LED is on in your Eaton UPS, it means the equipment is powered but not protected by the UPS. Check for overtemperature, overload, or UPS failure alarms.
How to fix Eaton 9PX 2200 GRT UPS overtemperature LED on and beeping?
If the UPS internal temperature is too high or a fan has failed and the Eaton UPS overtemperature LED is on, and it beeps every 3 seconds: * Clear vents and remove any heat sources. * Ensure airflow around the UPS is not restricted. * Restart the UPS. If the condition persists, shut down the UPS and contact your service representative. If the UPS transferred to Bypass mode, it will return to normal operation when the temperature drops 5°C below the warning level.
Why does my Eaton 9PX 2200 GRT UPS not start?
If the Eaton UPS does not start, check the input connections. Also, if the UPS Status menu displays the "Remote Power Off" notice, inactivate the RPO input, because the Remote Power Off (RPO) switch might be active or the RPO connector might be missing.
Why is my Eaton UPS not providing the expected backup time?
If the Eaton UPS does not provide the expected backup time, apply utility power for 48 hours to charge the batteries. If the condition persists, contact your service representative.
What does it mean when the battery fault LED is on and my Eaton UPS is beeping continuously?
If the battery fault LED is on and the Eaton UPS beeps continuously, verify that all batteries are properly connected. Start a new battery test: if the condition persists, contact your service representative. The battery test failed due to bad or disconnected batteries, or the battery minimum voltage was reached in ABM cycling mode.
Precautions and directives to be observed for personnel handling the UPS and its batteries.
Specific safety measures for handling heavy units, battery replacement, and repair procedures.
Guidelines for safe installation and operation of the UPS unit, including electrical and environmental considerations.
Step-by-step guide for connecting the internal batteries within the UPS unit.
Instructions for plugging in the Extended Battery Module power and detection cables.
Details connecting the UPS to the AC power source and loads without the HotSwap MBP.
Explains how to connect the UPS and equipment to the HotSwap MBP module for serviceability.
Details programmable signal inputs (RPO, ROO) and their functions for remote UPS control.
Provides steps for starting the UPS, verifying connections, and confirming normal operation.
Instructions for initiating a cold start of the UPS using battery power.
Detailed, step-by-step instructions for safely replacing the internal battery pack of the UPS.
Procedure for servicing or replacing the UPS unit with a HotSwap MBP module without interrupting loads.
A troubleshooting chart to identify UPS conditions, possible causes, and recommended actions.
General