Why is firmware download not possible on my Eaton 9PX 8000i RT6U HotSwap Netpack?
Firmware download may be impossible because one of the two UPS units is in Online or Battery mode. To resolve this, select Standby or Bypass mode.
What to do if my Eaton 9PX 8000i RT6U HotSwap Netpack displays 'Load unbalance'?
If your Eaton UPS displays 'Load unbalance', it could be because one of the "UPS output" switches is off on the back of the ModularEasy. Switch on the "UPS output" switch on the ModularEasy to fix this.
General| Model | 9PX 8000i RT6U HotSwap Netpack |
|---|---|
| Category | UPS |
| Output Power Capacity | 8000 VA / 7200 W |
| Form Factor | Rack/Tower |
| Rack Height | 6U |
| Hot-Swappable Batteries | Yes |
| Network Management | Yes |
| Display | LCD |
| Nominal Output Voltage | 230 V |
| Input Voltage | 230 V |
| Input Voltage Range | 160-280 V |
| Output Connections | (6) IEC 320 C13, (6) IEC 320 C19 |
| Battery Type | Sealed, lead-acid |
| Communication | USB, Serial |
| Efficiency | Up to 94% |
Details connection instructions, circuit protection, installation environment, and storage requirements.
Details protective devices and cable cross-sections for 9PXMEZ6Ki with specific UPS models.
Lists protective devices and cable cross-sections for 9PXMEZ11Ki with a common input AC source.
Details protective devices and cable cross-sections for 9PXMEZ11Ki with separate AC sources.
Provides step-by-step instructions for connecting power cables to the 9PXMEZ6Ki unit.
Guides on starting up a parallel UPS system, including mode selection and necessary checks.
Provides instructions for performing maintenance procedures on UPS units with the ModularEasy.
Details the process for removing a faulty UPS unit and replacing it within the system.
To Next Page
