Eaton 9PX 8000i RT6U HotSwap Netpack - Safety Instructions

Page 2
614-09354-01_EN
Special symbols
The following are examples of symbols used on the ModularEasy to alert you to important information:
RISK OF ELECTRIC SHOCK - Observe the warning associated with the risk of electric shock symbol.
Important instructions that must always be followed.
This symbol indicates that you should not discard waste electrical or electronic equipment (WEEE)
in the trash. For proper disposal, contact your local recycling/reuse or hazardous waste center.
Information, advice, help.
SAVE THESE INSTRUCTIONS. This manual contains important instructions
that should be followed during installation and maintenance of the ModularEasy and UPS.
The ModularEasy models that are covered in this manual are intended for installation in an environment
within 0 to 40°C, free of conductive contaminant.
These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct the interference at his own
expense.
Certication standards (in use with UPS)
• Safety: IEC/EN 62040-1 / Ed.1: 2008.
• EMC: IEC/EN 62040-2 / Ed.2: 2006.
• Performance: IEC/EN 62040-3 / Ed.2.0: 2011.
• IEC 61000-4-2 (ESD): level 3.
• IEC61000-4-3(Radiatedeld):level3.
• IEC 61000-4-4 (EFT): level 4.
• IEC 61000-4-5 (Fast transients): level 4.
• IEC61000-4-6(Electromagneticeld):level3.
• IEC61000-4-8(Conductedmagneticeld):level4.
SAFETY INSTRUCTIONS