Eaton 9PX 6K SP User Manual

Page 4
9PX-6K-SP_EN
SAFETY INSTRUCTIONS
Special precautions
• The unit is heavy: wear safety shoes and use vacuum lifter preferentially for handling operations.
• All handling operations will require at least two people (unpacking, lifting, installation in rack
system).
• For EBM, straps are provided only for unpacking manually the unit from the carton; don’t use the
straps to carry the unit around. The unit can slip from the straps during handling (risk of injury and
product damage):
- keep 12in / 30cm minimum distance between the straps
- lift the unit carefully and keep it at low height
- keep the unit horizontal during unpacking.
• Before and after the installation, if the UPS remains de-energized for a long period, the UPS must be
energized for a period of 24 hours, at least once every 6 months (for a normal storage temperature
less than 77°F (25°C)). This charges the battery, thus avoiding possible irreversible damage.
• During the replacement of the Battery Module, it is imperative to use the same type and number of
element as the original Battery Module provided with the UPS to maintain an identical level of
performance and safety. In case of doubt, don’t hesitate to contact your EATON representative.
• All repairs and service should be performed by AUTHORIZED SERVICE PERSONNEL ONLY.
There are NO USER SERVICEABLE PARTS inside the UPS.

Eaton 9PX 6K SP Specifications

General

Power Rating	6000 VA / 5400 W
Topology	Double Conversion Online
Typical Recharge Time	3 hours to 90%
Form Factor	Tower
Operating Temperature	0 to 40 °C
Humidity	0-95% relative humidity, non-condensing
Warranty	2 years
Output Power Factor	0.9
Input Voltage	200-240 VAC
Output Voltage	200/208/220/230/240 VAC
Battery Type	Sealed Lead Acid
Communication Ports	USB, RS-232
Storage Temperature	-15°C to 45°C (5°F to 113°F)
Certifications	CE
Output Receptacles	1 x IEC 320 C19
Efficiency	Up to 94% in online mode, up to 98% in high-efficiency mode