Eaton Cutler-Hammer DS Series - Moving Contact Details DS-840

Page 50
16-------
1.8. 33-790-11
----------"--"----~--~n
--~~~~~~~~~~~-@)
1 . Arcing Contact
9. Hinge Springs - Outer
2. Moving Arm - Outer Link
10. Hinge Spring - Center
3. Main Contact
11. Spwing
4. Operating Unk - Upper Pin
12. t.oCking Nut
5. Fl-Od End
13. ~Assembly
6. Adjusting Nut
14. Hinge Bearing Tube
7.
Moving
Arm -
15. Adjustment Locking Clip
Inner Links
- Straight
16. Insulating
Link
8. Moving Arm -
Inner
Un ks • Offset
NOTE
1 • Raised bearing
surf«e on each arm must be in contact
with stationary hmge surface.
Fig. 52 Moving Contact Details DS-840 (391084)
Effective October 1998
Courtesy of NationalSwitchgear.com