19
MECHANICAL
Cutout Dimensions: 3.62 W x 1.77 H (92mm x 45mm) DIN standard
Outline Dimensions: 4.04 W x 2.19 H x 3.87 D (103mm x 56mm x 98mm)
3.60 (92mm) maximum depth in panel
Enclosure: Plastic with polyester front label
Connectors: Up to five de-pluggable terminal blocks
INPUT POWER
AC Powered Models (57701-4XX)
Input Power: 85-265 VAC, 47-63 Hz, 20 VA
External Fuse: 0.2A, 250 VAC, Time Delay (T200mA, 250V)
Isolation Dielectric Strength: 2300 VAC
DC Powered Models (57700-4XX)
Input Power: 9-30 VDC, 12 VA
External Fuse: 2.0A, 50 VDC, Time Delay, (T2A, 50V)
Reverse Voltage Protection: Yes
Isolation Dielectric Strength: 2300 VAC to signal inputs and relays, 500 VAC to
RS 485 and analog outputs
HUMAN INTERFACE
Display: 5 digits
Type: .56 high, seven segment, red LED
Indicator: One red LED program/calibration indicator
Update Time: 0.1 to 99.9 seconds minimum
DATA RETENTION
Memory Type: EEPROM, no batteries required
Duration: 100 years
SIGNAL INPUT
Rate/Process Time: Signal In
Sensor Type: Sink or source, DIP switch selectable
Input Impedance: 4.75 k ohms to +5 VDC or 34.9 k Ohms to ground
Threshholds: High 3.5 to 28 VDC, low 0 to 1.9 VDC, for single
ended signals
Magnetic Pickup Range: 200 mV p-p to 65 VRMS into 34.9 k Ohms
Frequency Response: 200 Hz max. or 10 kHz max. (5 V signals), DIP
switch selectable
PROGRAM ENABLE INPUT
Sensor Type: Sink only
Input Impedance: 4.75 k Ohms to +5 VDC
SPECIFICATIONS
To Next Page
Loading...
Need help?
General
