Need help?Do you have a question about the Eaton MGR10 and is the answer not in the manual?
General| Brand | Eaton |
|---|---|
| Model | MGR10 |
| Category | Measuring Instruments |
| Language | English |
Provides a general introduction to the MGR10 Microhmmeter and its purpose.
Details the technical specifications for MGR10 and MGR10A models.
Covers specifications and conditions applicable to all MGR10 models.
Crucial safety instructions and precautions for operating the MGR10.
Guide on how to unpack the MGR10 and check its contents.
Description of the MGR10's front panel layout and components.
Explains how to use the function keypad for measurements and programming.
Details the information displayed on the MGR10's LCD screen.
Covers manual and auto range selection methods for measurements.
Explains how to configure the measurement current magnitude and mode.
Describes how to apply temperature compensation for accurate readings.
Explains how to set high/low limits for component sorting.
Explains how to connect measuring leads to the MGR10 instrument.
Details the four-wire connection method to the resistance under test.
Step-by-step guide for performing a standard resistance measurement.
Describes setting up and using the PLC interface for remote control.
Overview of serial and parallel interfaces for remote communication.
Details the command language and syntax for remote programming.
Lists commands for configuring measurement parameters via interfaces.
Mapping of RS-232 pin connections between PC and MGR10.
Describes available lead sets for use with the MGR10.
Lists optional interfaces and accessories for the MGR10.
Procedure for returning the instrument for service or repair.
Guidelines for basic maintenance and troubleshooting common issues.
To Next Page