MGR10 A/B/C - Revision : I (for 7.0 software revision) 105
SECTION 7 : ACCESSORIES
7.1 LEADS
The MGR10 may be used with a variety of lead sets. The following are the available selection.
Remember, if you do not see suitable leads for your application ,please consult our customer
help desk.
Ordering Code Description
TE66 4 wires continuity measurement set including a CO183 (
banana terminal and crocodile clip ) and a CO184 (
retractable metallic tip probe )
TE80 2 wires probe with 1 .5 meters cable length and remote
control system
CO183 2 wires continuity measurement lead with 4 mm diameter
banana plugs and crocodile clip
CO184 C2 wires continuity measurement lead with retractable tip
probe .
CO64 4 wires continuity measurement lead with 2 Kelvin clips
7.2 OPTIONS
The MGR10 can be equipped with the following options :
Ordering code Description
01 RS232C serial Interface ,talker and listener
02 PLC interface
04 PT100 temperature measurement probe
05 Rear panel outputs
06 IEEE488 parallele Interface ,talker
MGR10A Battery powered version
To Next Page
Loading...
Need help?
General
