MGR10 A/B/C - Revision : I (for 7.0 software revision) 14
SECTION 2 : SETTING UP THE MGR10
2.1 Safety information
Please read and follow these important safety instructions:
Read the safety information at the beginning of this manual before operating the MGR10;
Make the necessary electrical safety connection checks. In particular, select the correct line voltage
and make sure that the correct fuse is installed. Incorrect voltage or fuse selection present both an
electrical safety and a fire hazard. Ensure that the rear panel fan is operating and that the vent is not
blocked.
When connecting to an electrical supply mains supply, the mains cord provided with the equipment
should be used, and connected only to a mains supply with a suitable earth connection. Under no
circumstance should the equipment be operated with earth disconnected.
2.2 Unpacking the instrument
When you unpack the MGR10, check that the following items are present before starting to use the
unit:
1 x MGR10 Microhmmeter
1 x Mains Cord
1 x Operating manual
1 x Calibration Certificate
Please contact the Sefelec Customer Support Team immediately if any of these items are missing or
damaged.
To Next Page
Loading...
Need help?
General
