EasyManuals Logo

Eaton MGR10 User Manual

Eaton MGR10
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
MGR10 A/B/C - Revision : I (for 7.0 software revision) 48
6-1-3 Logical states definition :
Input :
The high logical state is defined by a DC or AC voltage presence between the Umin and the
Umax values .
The low logical state is defined by no voltage .
Output :
The high logical state is defined by a closed contact .
The low logical state is defined by an opened contact .
6-1- 4 Connection :
All the IO lines are available on a female Sub-D type 25 pins connector on the unit rear panel .
1 Not connected
2 0 Volt
3 25 Volts DC protected by internal fuse ( 1AT)
4 Input for PLC option : CTRLIN
5 Input for PLC option : N1
6 Input for PLC option : N3
7 Input for PLC option : MES_DCH
8 Output Common : COM_OUT
9 Output for PLC option : FAIL HIGH
10 Output for PLC option : PASS
11 0-10 volts output , ground point
12 Frame
13 Not connected
14 Not connected
15 Not connected
16 Input Common : COM_IN
17 Input for PLC option : N0
18 Input for PLC option : N2
19 Not connected
20 Output for PLC option : FAIL LOW
21 Output for PLC option : CTRLOUT
22 Output for PLC option : EOT
23 Output for PLC option : ERROR
24 0-10 volts output , positive pole
25 Not connected

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Eaton MGR10 and is the answer not in the manual?

Eaton MGR10 Specifications

General IconGeneral
BrandEaton
ModelMGR10
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals