21
3. Installation
3.1 Unpacking and Inspection
3.1.1 Unpack the package and check the contents. The shipped
package contains:
⚫ 1 UPS
⚫ 1 user manual
3.1.2 Inspect the appearance of the UPS to see if there is any damage
during transportation. Do not turn on the unit and notify the dealer
immediately if there is any damage or lack of some parts.
3.2 Installation steps
1) Make sure the wire / circuit breaker / socket are enough for the
current rating of UPS to avoid the hazards of electric shock and
fire. It is recommended to use 10AWG for 3K.
2) Make sure the mains switch in the building is cut off.
3) Make sure the UPS is not being turned on before wiring
operation.
4) Turn off all load switches first before connecting the load to the
UPS.
5) Connect the loads to the UPS through the outlet sockets.
3.3 Installation steps for external battery
1) Make sure the wire / circuit breaker / socket are enough for the
power rating of UPS to avoid the hazards of electric shock and
fire.
2) Make sure the mains switch in the building is cut off.
3) Turn off all load switches first before connecting the load to the
UPS.
4) Make sure the protective earth ground is correct.
To Next Page
Loading...
