27
3) If you want to turn off the output of UPS and shut down the UPS
completely, you have to cut off the mains input of UPS.
Note: please make sure all the loads are prepared or turned off
for your operation before you shut down the UPS system.
4) After you cut off the mains input of UPS to shut down. After a few
seconds, the UPS will be shut down completely and the LCD
extinguish.
4.8 Turn off the UPS with battery (DC source) only
1) To turn off the UPS in battery mode, please press the off-button
continuously for more than 1 second.
2) After you press the button, the buzzer will beep once. After a few
seconds, the UPS will be shut down completely and the LCD
extinguish.
Note: please make sure all the loads are prepared or turned off
for your operation before you shut down the UPS system.
4.9 Mute the buzzer
If the alarm is too annoying in battery mode, you may press on-
button continuously for more than 1 second to clear it. Moreover, the
alarm will be enabled when the battery is low to remind you to shut
down the load soon.
If the alarm is too annoying in bypass mode, you may press
off-button continuously for more than 1 second to clear it. The action
doesn’t affect the warning and fault alarm.
4.10 Operation in warning status
1) In case the Fault/Warning icon is flashing, and the buzzer is
beeping once every second, it shows that the UPS system have
some troubles, please check the troubleshooting table in chapter
4 to find out what happen to the UPS.
2) If the warning happens, the UPS will continue work in the
original mode, the operation will not be interrupted. If the error is
corrected, the warning alarm will stop.
To Next Page
Loading...
