23
j) Check the wiring and voltage of the battery pack. Make sure
the polarity and voltage is correct, and the wires are
fastened.
6) Connect the loads to the UPS through the outlet sockets.
7) Connect the input power cord of UPS to mains
3.4 Installation for communication software (optional)
1) Connect the communication cable between UPS and PC. If the
port is RS232, please lock the secure screw both on UPS and
PC after connection. If the port is USB, it has Plug and Play
function.
2) Please refer to the guide manual of software or contact the
service center for installation and operation of management
(monitoring) software.
To Next Page
Loading...
