Eaton ER9.3-10 - Pin Assignment on Back Connector X1

ç è é.ê ëì íî4ï ðñ8òó ô.õîö ÷ ø ÷ ö ù ò@õ ñ.ö ø ò8ú û ü
ý þ ÿ    þ  ÿ    
          ! " # $&%(') *,+.-.) /%%0
1 2 3 4 2 5 6 7
8.9:;(9< =?> @BADCFEFCFCFCFCHGJI(KFLFGHC M N O P
32
Q R
48
Pin Assignment on Back Connector X1
Table 2 shows the pin assignment on the 48 pin connector of card holder HC000000315303. Values
in brackets {} have no function in proportional valve adjustment displacement control mode (SP). The
wiring scheme, necessary for SP-Control is shown in Fig. 7. Additional wiring, e.g. to use monitoring
function, can be done optional by customer.
Pin d b z
2
0 V (External) DIO 1 (S1.08 if
activated)
- Sign (direction) digital set
values
4
Digital set value 2 (S1.02) {DIO 2 / Channel-B} + Sign (direction) digital set
values
6
Digital set value 3 (S1.03) {DIO 3 / 0-Pulse} Digital set value 4 (S1.04)
8
ENABLE (DI 1) Reserved Digital set value 1 (S1.01)
10
Sensor 1 (FB 1) U
E
, I
E
Analog output {RxD (RS232)}
12
Analog set value 6 U
E+
(S1.06)
{TxD RS232} Analog set value 5 U
E+
(S1.05)
14
ERROR (DO 1) COMPARATOR (DO 2) {Sensor 2 (FB 2) U
E
}
16
Analog set value 6 U
E-
(S1.06)
{reserved} Analog set value 7 I
E
(S1.07)
18
Digital GND PE Ramp = 0 (DI 2)
20
Reference output - 10.0 V Break output 24 V / 1 A Reference output + 10.0V
22
Solenoid output A - Solenoid output A - Solenoid output A -
24
Solenoid output B - Solenoid output B - Solenoid output B -
26
0 V (Power) 0 V (Power) Analog GND
28
Solenoid output A + Solenoid output A + Solenoid output A +
30
Solenoid output B + Solenoid output B + Solenoid output B +
32
+ 24 V (Power) + 24 V (Power) 24 V (External)
Table 2: Pin Assignment 48 pin connector