Eaton EX RT7 - Rack Installation

86-86000-01 B01 - Page 6
STEP 3 Rack Kit (continued)
Power Module Front Panel Display and Rack Installation
E
X 1
1
R T
OF
F
O
N
E
X
1
1
R
T
O
F
F
O
N
E
X
1
1
R
T
O
F
F
O
N
E
X
1
1
R
T
O
FF
O
N
1
2
3
FINISHED PANEL
(rack orientation)
1
2
3
A.
Prepare the front panel logo and LCD display for rack
orientation, of all modules (including transformer module,
CLA charger, if equipped).
B. Rack Installation
O
FF
O
N
EX 11 RT
EXB RT
EX RT Transformer
2. POWER MODULE
(middle, EX RT 5/7/11)
3. BATTERY MODULE
(bottom, EX RTEXB 5/7/11)
1. EX RT Transformer
(Top, EX RT 5/7/11)
Layout of Modules in Rack Configuration
3
4
4
4
4
2
2
1
4
4
5
1
6
6
6
6
1. Attach both front mounting ear
brackets to module with supplied
screws. (For this step, it is possible to
adjust the position of both front
mounting brackets.)
2. Attach rear support brackets to
module. These brackets prevent the
module from sliding out of the rack.
3. Attach rails together and secure with
wing nuts, and finger tighten. (both
sides).
4. Attach both rails to rear and front of
rack with supplied flathead screws (as
shown).
5. Use caution when sliding unit into rack.
Temporarily secure unit to rack with
thumb screws on front mounting
brackets.
6. Secure rear support brackets to rails.