To Next PageTo Next Page
Need help?Do you have a question about the Eaton Greengate RC3D-PL-N and is the answer not in the manual?
General| Category | Controller |
|---|---|
| Manufacturer | Eaton |
| Model | Greengate RC3D-PL-N |
| Input Voltage | 120-277V AC |
| Number of Inputs | 3 |
| Number of Outputs | 3 |
| Protection Rating | IP20 |
Provides critical safety information for installation and use.
Details electrical ratings, load capacities, and operating environment for the Room Controller.
Instructions for mounting the Room Controller above the entrance door.
Instructions for connecting lighting load wiring and 0-10V dimming circuits.
Visual representation of all wiring connections for the Room Controller.
Details the setup for the RC3DE model's 3A emergency relay for lighting control.
Explains how to wire up to three 0-10V dimming zones for flexible control.
A step-by-step checklist to verify optimal operation of the Room Controller after installation.
Guides users through adjusting minimum and maximum light output levels using trim dials.
Details how to use the HHPRG-RC remote to adjust dimming levels and set commissioning mode.
Explains how to check and adjust the daylight sensor's range for accurate light level detection.
Resets default light levels using the HHPRG-RC remote and onboard gain adjustment dials.
Diagnoses issues with emergency lighting not activating in the designated zone.
Diagnoses lighting that stays dimmed and does not respond to raise controls.
Investigates why daylight dimming is not working automatically while manual dimming is functional.
Troubleshoots lighting stuck at full brightness, unresponsive to lower controls.
