Matrix Telecom Inverter System
2
Copyright © 2008-2010 Eaton Corporation. All Rights Reserved.
IPN 997-00012-68D February 2010
Features:
• Pure Sine Wave Output with low distortion
• Versatile module design forms a variety of arrangements for different power needs
• Easily expands capacity up to 12 units with N+1 redundancy configuration
• "All master" dynamic mechanism eliminate single point failure to optimize reliability
• Hot-pluggable connection allows module addition or removal with no operation stop
• Ultimate high power density reducing space demand
• High efficiency (> 89%)
• Comprehensive LCD/LED display provides system status, and user-friendly panel eases
program settings.
Modules
Inverter Module
The four inverter modules available are hot-swap, with -48Vdc input to 1000VA or 1500VA
output at 120 or 230VAC, 50 or 60Hz. See Part Numbers on page 5
.
The 19-inch hot-swap compatible inverter chassis is designed to parallel connect and
synchronize all inverter modules. With this chassis, the Matrix has N+1 redundancy with up to
12 inverter modules to prevent any interruption if an inverter module fails.
"
Lock bolt
#
Power on LED (green)
$
Warning LED (yellow)
%
Fault LED (red)
Controller Module (optional)
The DSP microprocessor technology of the controller (INV-MC-1000) gives real-time system
status through the front panel LEDs, and allows program settings through the keypad and LCD
display.
"
Power on LED (green)
#
Warning LED (yellow)
$
Fault LED (red)
%
Function keys
!
LCD screen
To Next Page
Loading...
