Eaton Power Xpert 9395 - Figure 4-3. Battery Cabinet to Battery Cabinet Joining Brackets

INSTALLATION
Power Xpert 9395 Integrated Battery Cabinet (Model 1085 and 1085HR) Installation Manual S 164201687 Rev 4 www.eaton.com/powerquality
4-5
NOTE Two cabinet joining brackets are provided for securing each cabinet at the top and bottom. A flat
bracket joins the top of the cabinets and a larger flat bracket joins the cabinets at the bottom. The small flat
bracket is attached to the cabinet tops first.
8. Remove the left‐hand and right-hand screws from the adjacent top door hinges
of the battery cabinets.
9. Locate the small flat bracket from the field kit. Align the holes in the small flat
bracket over the hinge screw holes. Replace the screws in the hinges, securing
the bracket to the cabinets (see Figure 4‐3).
10. Locate the large flat bracket from the field kit. Place the bracket over the bolts on
the bottom side of the adjacent lower hinges on the battery cabinets (see
Figure 4‐4).
Bracket
from Kit
Existing Screws
Top View with Small Bracket
Battery Cabinet 1
Battery Cabinet 2
Large Bracket
(see Figure 4‐4)
NOTE When cabinets are properly aligned, all cabinet doors are flush.
Figure 4‐3. Battery Cabinet to Battery Cabinet Joining Brackets