Eaton Power Xpert 9395 - Warranty

INSTALLATION
Power Xpert 9395 Integrated Battery Cabinet (Model 1085 and 1085HR) Installation Manual S 164201687 Rev 4 www.eaton.com/powerquality
4-9
7. Route and connect the battery disconnect output cables to the UPS cabinet
battery input terminals E4 and E5 and ground terminals. Refer to the applicable
Power Xpert 9395 Installation and Operation manual listed in paragraph 1.7 for
UPS cabinet terminal locations and termination requirements.
8. Repeat Steps 1 through 7 for each battery cabinet, and then proceed to
paragraph 4.3.3.
Cabinet to UPS Negative
Terminals ()
Cabinet to UPS Positive
Terminals (+)
Interface Terminal Block TB1
and Connectors J3 And P3
(see Figure 4‐10 For details)
Battery Breaker
Ground Terminal
NOTE Use pressure and bus bar terminations as necessary for connecting cables between the UPS and battery cabinets.
Inter‐Cabinet Wiring Access
to Route Interface Wires
Between Cabinets
Inter‐Cabinet Wiring Access
to Route Interface Wires
Between Cabinets
EMP Mounting Location
(if installed)
Ground StudGround Stud
Figure 4‐7. 1085 Battery Power and Interface Terminal Locations