Eaton PowerXL DM1 Series - Page 110

100
Chapter 6 - Pump control application
POWERXL DM1 SERIES VARIABLE FREQUENCY DRIVES MN040049EN—September 2021 www.eaton.com
Table 39. Multi-pump measurement (*DM1 Pro) (Cont.).
M8.7.2
Drive 2
ID 2239
Minimum value:
rpm
Maximum value:
rpm
Default value:
rpm
Description:
Provides the motor speed (rpm) of drive 2 while using the multi-pump mode.
M8.7.3
Drive 3
ID 2251
Minimum value:
rpm
Maximum value:
rpm
Default value:
rpm
Description:
Provides the motor speed (rpm) of drive 3 while using the multi-pump mode.
M8.7.4
Drive 4
ID 2263
Minimum value:
rpm
Maximum value:
rpm
Default value:
rpm
Description:
Provides the motor speed (rpm) of drive 4 while using the multi-pump mode.
M8.7.5
Drive 5
ID 2275
Minimum value:
rpm
Maximum value:
rpm
Default value:
rpm
Description:
Provides the motor speed (rpm) of drive 5 while using the multi-pump mode.
M8.8 - Run time (*DM1 Pro).
M8.8.1
Drive 1
ID 2228
Minimum value:
Hours
Maximum value:
Hours
Default value:
Hours
Description:
Provides the motor run time (h) of drive 1 while using the multi-pump mode.
M8.8.2
Drive 2
ID 2240
Minimum value:
Hours
Maximum value:
Hours
Default value:
Hours
Description:
Provides the motor run time (h) of drive 2 while using the multi-pump mode.
M8.8.3
Drive 3
ID 2252
Minimum value:
Hours
Maximum value:
Hours
Default value:
Hours
Description:
Provides the motor run time (h) of drive 3 while using the multi-pump mode.
M8.8.4
Drive 4
ID 2264
Minimum value:
Hours
Maximum value:
Hours
Default value:
Hours
Description:
Provides the motor run time (h) of drive 4 while using the multi-pump mode.
M8.8.5
Drive 5
ID 2276
Minimum value:
Hours
Maximum value:
Hours
Default value:
Hours
Description:
Provides the motor run time (h) of drive 5 while using the multi-pump mode.
M9 - Multi-monitoring (for remote keypad only).
M9.1
Multi-monitoring
ID 30
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
0, 1, 2.
Description:
Displays any three monitoring values in a single screen. The values are selectable via the keypad menu. Multi-monitor page could
see three lines of monitoring values. Up and down keys can be used to select the row and then hitting the left arrow key will allow for
editing the value then by going up and down.