Eaton PowerXL DM1 Series - Page 93

83
Chapter 5 - Fan control application
POWERXL DM1 SERIES VARIABLE FREQUENCY DRIVES MN040049EN—September 2021 www.eaton.com
Table 34. Ethernet communication (Cont.).
P12.1.6
a
Static IP address
ID 1501
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
192.168.1.254
Description:
Defines the static IP address.
P12.1.7
a
Static subnet mask
ID 1503
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
255.255.255.0
Description:
Defines the static subnet mask.
P12.1.8
a
Static default gateway
ID 1505
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
192.168.1.1
Description:
Defines the static default gateway.
P12.1.9
Ethernet communication timeout
ID 611
Minimum value:
0 ms
Maximum value:
60,000 ms
Default value:
10,000 ms
Description:
Selects the time it waits before a communication fault occurs over ethernet.
P12.2 - Trusted IP filter (DM1 PRO only).
P12.2.1
Trusted IP white list
ID 68
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
192.168.1.255
Description:
Defines the IP addresses in the white list. A setting of 192.168.1.255 enables all connections on the local subnet.
P12.2.2
Trusted IP filter enable
ID 76
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
1
Options:
0 = Disabled; or
1 = Enabled.
Description:
Enables IP white listing. Devices not in the white list will not be able to establish communications with the drive.
P12.3 - Modbus TCP (DM1 PRO only).
P12.3.1
a
Modbus TCP enable
ID 1942
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
0
Options:
0 = Disable; or
1 = Enable.
Description:
Enables modbus TCP communications, must be enabled to connect to Power Xpert inControl.
P12.3.2
Modbus TCP connection limit
ID 609
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
5
Description:
Maximum number of connections allowed to the drive.