Eberspächer Easystart Remote + - WHAT TO DO IF...?; Troubleshooting Common Displays

VEHICLE HEATERS – TECHNICAL DOCUMENTATION | 17
4 WHAT TO DO IF …?
In the event of a fault the following displays are possible:
DISPLAY DESCRIPTION REMEDY / WORKSHOP
Pair mode
Add
 Automatic detection is active.
 The EasyStart Remote
+
has
been disconnected from the
power supply and then recon-
nected.
Wait until the automatic detection
has finished, then set the time
and weekday, see page 12.
Pair mode
AddE
 Battery dead. Replace the battery immediately!
NO SIGNAL
 No communication.  Check and if necessary renew
the heater fuse.
 Check the voltage supply.
 Check the wiring.
Error
 1st heater fault. Perform the heater diagnosis.
Error
 2nd heater fault. Perform the heater diagnosis.
18:30  °C
 Temperature sensor defective. Check and if necessary renew
the temperature sensor.