Need help?Do you have a question about the EBIKELING NC-81F and is the answer not in the manual?
Summarizes the display's features, including battery, PAS, speed, mileage, walk boost, and light functions.
Details specific display elements like battery level, error code, current speed, walk boost, and odometer.
Instructions for powering the display on and off, and its automatic shut-off feature.
How to cycle through different display screens like Trip Odometer, Odometer, and speed.
Guide on activating and using walk boost mode and cruise control features.
How to control the display backlight and bicycle lights using the designated button.
Adjusting the Pedal Assist System (PAS) level to modify motor output power.
Explanation of the 5-bar battery indicator and low battery warnings.
Information on how error codes are displayed and the need for troubleshooting.
How the display indicates braking activity with a 'br' prompt.
Instructions for adjusting the display's backlight brightness levels (01, 02, 03).
Switching between metric (km/h) and imperial (mph) units for speed and distance.
Configuring the display for the bicycle's rated voltage (36V, 48V, 52V).
Setting the auto-sleep timer to conserve battery power, with adjustable range and default.
Adjusting available Pedal Assist System (PAS) levels (0~3, 0~5, 0~9).
Setting wheel diameter (1-50 inches) for accurate speed and distance readings.
Configuring the number of speed sensor magnets (1-255 pcs) for accurate readings.
Setting the maximum speed limit for the electric bicycle (1-100 km/h).
Choosing start modes: zero start (00) or non-zero start (01).
Selecting drive mode: Pedal assist only (00), Electric only (01), or Both (02).
Adjusting pedal assist sensitivity based on crank rotations (1-24).
Setting pedal assist strength from 0 (weakest) to 5 (strongest).
Setting the number of pedal assist sensor magnets (5-12 pcs).
Setting the controller's maximum current limit (1-50A).
Configuring odometer reset behavior: non-reset (00) or reset (01).
Activating and setting a four-digit power-on password for the display.
Instructions for restoring the display to its factory default parameter settings.
Manual procedure to reset the trip odometer, as it does not reset automatically.
Details on the limited warranty offered, including duration and conditions.
List of conditions and damages not covered under the product warranty.
Diagrams and explanation of controller and display connectors, including pin assignments.
To Next Page
General