March 2013 43 IPV58
2.7.1 To change the camera’s port. (Always change your port!)
Open the IP Camera Tool from your Desktop select the ebode camera (it will turn blue) and right-mouse
click and choose network configuration. The default port of the camera is “80”, please change “80” to any
other port you like, such as 81, 82, 83 etc. Click “OK”, the camera will reboot, wait about 30 seconds.
Figure 7.4
2.7.2 DDNS Status (Always check!)
After all these steps are done you should be able to access your camera from your mobile device or tablet
using an app or your web browser.
Before you have remote access to the camera, you first need to check the DDNS status from the camera.
Login to the camera and choose “System”>”Device Info”. Please check that ‘DDNS Status’ shows
‘succeed’ followed by the address. This is illustrated in the image below. It is important that you get the
address link of DDNS to access the camera from anywhere in the world. You can also find this address on
the bottom of your camera. Write this address somewhere or add it as a favorite in your web browser to visit
the camera from outside the network (from your mobile device for example at work, school, on the road
etc.)
Figure 7.8
To Next Page
Loading...