Ebode IPV58 - Camera Product Specifications

March 2013 69 IPV58
How to register an account from DDNS web
You can enter http://www.dyndns.com and register an account.
Pop-up the prompt” Fail to connect to the device…”?
This prompt only appears in the case of using multiple cameras.
When you set multiple cameras, and the device status light changes to yellow please make sure the
cameras are connected to power and working correctly.
4.2 Default Parameters
Default network Parameters
IP address: dynamic
Subnet mask: dynamic
Gateway: dynamic
DHCP: Disabled
DDNS: factory DDNS and third party DDNS
Username and password
Default administrator username: admin
Default administrator password: None, i.e., no password
6.0 Specifications
Model
IP Vision 58
Image Sensor
Sensor
1/4” Color CMOS Sensor
Resolution
640 x 480 Pixels (300k Pixels)
IR Lens
f: 3.6mm, F 2.0 (6mm lens optional)
Viewing Angle
90 Degree (6mm lens is 60Degree)
Minimum Illumination
0.5Lux @ F2.0
Video / Image Setting
Video Compression
MJPEG
Video Frame Rate
15fps(VGA), 30fps(QVGA)
Resolution
640 x 480(VGA), 320 x 240(QVGA)
Flip Mirror Images
Vertical / Horizontal
Light Frequency
50Hz, 60Hz or Outdoor
Video Parameters
Brightness, Contrast
Communication
System Interface
10Base-T/100Base-TX Ethernet Port
Supported Protocol
TCP/IP，DHCP，SMTP，HTTP，DDNS，UPNP，PPPoE, FTP, DNS, UDP, GPRS
Wireless LAN
Support wireless network (Wi-Fi/802.11/b/g)
WEP Encryption
Disable / 64 bit / 128 bit
WPA/WPA2
Encryption
TKIP / AES