Ebyte E104-BT52 - Quick start; 7.1 Configuration mode guidance

Copyright ©2012–2022，Chengdu Ebyte Electronic Technology Co.,Ltd
26
7 Quick start
Software for debugging and parameter setting：

PC serial tool - XCOM.exe;

Phone ble debugging APP - nRF connect
7.1 Configuration mode guidance
7.1.1 Serial port configuration

Confirm whether the module is currently in configuration mode (if not connected, the module can be
configured, if it is connected, you need to send "+++" through the serial port).

Set XCOM serial port related configuration (default configuration: 115200, 8, 1, none, no flow empty), as
shown below XCOM parameter configuration diagram;

Configure it according to AT command.
7.1.2 Configuration over air
 Only for module that works as a slave.
 Open app “nRF connect”, start scanning，find “E104-BT52” and connect to it.