What to do if there is no spark at the end of the plug wire in my Echo CS-352?
If there is no spark at the end of the plug wire on your Echo Chainsaw, the spark gap might be incorrect. Adjust it to be between 0.6 mm and 0.7 mm (0.024 to 0.028 in.). Other potential causes include a spark plug covered with carbon or fouled with fuel; in these cases, clean or replace the spark plug. If the spark plug is defective, replace it.
What to do if there is spark at the end of the plug wire in my Echo CS-352 Chainsaw?
If there is spark at the end of the plug wire of your Echo Chainsaw, make sure the ignition switch is turned on. If the switch is already on, there may be an electrical problem, and you should consult your ECHO dealer.
Essential guidelines and precautions for safe chainsaw operation and kickback prevention.
Instructions on how to use and test the chain brake for safety.
Comprehensive list of additional safety measures for operating the chainsaw.
Specifies approved gasoline and two-stroke oil for optimal engine performance and warranty.
Safety precautions for mixing, storing, and handling flammable fuel mixtures.
Step-by-step instructions for safely starting the chainsaw from a cold state.
Instructions for starting the chainsaw when it is already warm.
How to operate the chainsaw, including unlocking the brake and managing throttle.
Basic safety rules, kickback avoidance, and proper handling for cutting wood.
Detailed steps and safety precautions for felling trees correctly.
A table outlining routine maintenance tasks and their recommended frequency.
Troubleshooting chart for issues like engine not starting or dying during operation.
Troubleshooting for acceleration problems, engine dying, and failure to crank.
General| Engine Displacement | 34.0 cc |
|---|---|
| Engine Type | 2-stroke |
| Chain Pitch | 3/8 inch |
| Bar Length | 16 inches |
| Weight | 8.8 lbs |
| Power Output | 1.3 kW |
| Chain Gauge | 0.050 inch |
To Next Page
