18
Maintenance and care
Maintenance and care
Servicing guidelines
Maintenance and care
Cleaning battery and battery compartment
1. Release trigger switch and trigger switch lockout and allow
trimmer head to stop.
2. Make sure power indicator LED is not illuminated.
3. Depress battery pack latch release (A) slide battery pack out
of power head.
4. Use compressed air or a soft bristle brush to remove debris
from battery and battery compartment.
Checking the nylon line cutting head
1. Make sure each periphery of the 2 retaining pawls of housing
spreads almost fully up to the outer periphery of the respec-
tive cover window.
2. Check mount of cutting head on trimmer and tighten if it is
loose.
3. Check the cutter head for deflection or abnormal noise rotat-
ing it by hand. Deflection or abnormal noise can cause ab-
normal vibration to occur or mount to trimmer to loosen
during rotation which is dangerous.
WARNING
Observe the following precautions when checking and maintaining your product after use:
Turn power to unit off, remove battery, and make sure all moving parts have come to a complete stop.
An accident could occur if the product starts unexpectedly.
Allow unit to cool before performing service.
You could burn yourself.
IMPORTANT
Checking and maintenance requires specialist knowledge. If you are unable to check and maintain the product or deal with a
fault yourself, consult your dealer. Do not attempt to dismantle the product.
Area Maintenance Page Before use Monthly
Battery Inspect/Clean/Charge 10 •
Nylon line cutting head Inspect 18 •
Cut off knife Inspect/Clean - •
Screws, bolts and nuts Inspect, Tighten/Replace - •
If you have any questions or problems, please contact your dealer.
WARNING
Risk of electric shock or fire. Do not use conducting ma-
terials to clean battery or battery compartment.
To Next Page
Loading...
Need help?
General