20
Maintenance and care
8. Pull out the line from cover. (A) Remove the line from "re-
spective notch of spool", and (B) pass it through "groove of
respective eyelet".
9. Fit cover and housing together. (C) Align "eyelets" of cover
with "recesses" of housing, and (D) press pawls of housing
into respective window of cover until the pawls are firmly fit-
ted into the windows.
Troubleshooting table
DANGER
Make sure each outer periphery of pawls of housing
spreads almost fully up to the outer periphery of respec-
tive window of cover. If they are loosely fitted and the cut-
ting head is turned, cover or inside components can fly off
which is dangerous.
IMPORTANT
For spare parts and consumables, please use only genuine parts and designated products and components.
Using parts from other manufacturers or non-designated components may result in a malfunction.
Trouble Cause Remedy
Red Charger light flashes or does not
light up
1. Plug not connected to power outlet
2. Battery pack not installed properly
3. Obstructed connection
4. Fault in the charger
5. Fault in the battery pack
1. Plug in the charger
2. Check the battery pack installation
3. Reinstall battery pack again after re-
moving obstructions from connec-
tion.
4. Consult your dealer
5. Consult your dealer
Unit will not turn on 1. Battery pack not installed properly 1. Check the battery pack installation
Unit does not run when turned on 1. Battery pack discharged
2. Line head obstructed
3. Battery pack outside acceptable
temperature range
1. Charge the battery pack
2. Turn off the unit and clean the cut-
ting attachment
3. Remove the battery pack and allow
to cool
Running time is too short 1. Battery pack outside acceptable
temperature range
2. Unit electronics too hot
3. Battery pack discharged
1. Remove the battery pack and allow
to cool
2. Turn unit off and allow to cool
3. Charge the battery pack
Line won't feed 1. Not enough line on the spool
2. Line tangled in the spool
1. Rewind with new line
2. Unwind and rewind the line
Line fails to cut off 1. Cut off knife in the shield is damaged
or missing
1. Consult your dealer
Consult your dealer in the event of a problem that is not covered in the table above, or other such concerns.
Please contact your dealer in order to dispose of the product or its parts in compliance with national laws.
To Next Page
Loading...
Need help?
General