20
Maintenance and care
Maintenance and care
Servicing guidelines
Maintenance and care
WARNING
Observe the following precautions when checking and maintaining your product after use:
Turn the engine off and do not attempt to check or maintain the product until the engine has cooled.
You could burn yourself.
Remove the spark plug cap before performing checks and maintenance.
An accident could occur if the product starts unexpectedly.
IMPORTANT
Checking and maintenance requires specialist knowledge. If you are unable to check and maintain the product or deal with a
fault yourself, consult your dealer. Do not attempt to dismantle the product.
Area Maintenance Page Before use Monthly
Air filter Clean/Replace 21 •
Fuel filter Inspect/Clean/Replace 21 •
Spark plug Inspect/Clean/Adjust/Replace 23 •
Carburettor Adjust/Replace and adjust 21 •
Cooling system Inspect/Clean 22 •
Silencer Inspect/Tighten 22 •
Silencer Clean 22 •**
Angle transmission Grease 23 •*
Starter Inspect - •
Cut off knife Inspect/Clean - •
Fuel system Inspect 21 •
Screws, bolts and nuts Inspect, Tighten/Replace - •
* Or 50 hours, whichever occurs first. ** Or 100 hours, whichever occurs first.
Area Maintenance
Valve clearance Adjust
If pulling on the starter grip is difficult or power is low, consult
your dealer.
IMPORTANT
Time intervals are maximum. Actual use and your experience will determine the frequency of required maintenance.
If you have any questions or problems, please contact your dealer.
To Next Page
Loading...
Need help?
General
