wheeled trimmer
2
SAFETY
Set up your work site so you are not endangering traffic 1. 
and the public. Take  great care to provide  adequate 
warnings.
Keep  the  machine  clear  of  debris  and  other 2. 
accumulations.
On electric start models, disconnect cables from battery 3. 
before doing any inspection or service.  
When the trimmer bail is engaged, the trimmer disk is 4. 
rotating. Do not attempt to inspect or service the machine 
while the trimmer disk is rotating.
1.4   OPERATION SAFETY
Do  not  operate  this  equipment  in  the  vicinity  of 7. 
bystanders.  Keep the area  of  operation  clear  of  all 
persons, particularly small children.  It is recommended 
that bystanders keep at least 50 feet (15 meters) away 
from the area of operation. 
Do not allow children to operate this equipment.8. 
Use only in daylight or good artificial light.9. 
Do not run this equipment in an enclosed area.  Engine 10. 
exhaust  contains  carbon  monoxide  gas,  a  deadly 
poison that is odorless, colorless and tasteless.  Do not 
operate this equipment in or near buildings, windows 
or air conditioners.
Always use an approved fuel container.  Do not remove 11. 
gas cap or add fuel when engine is running.  Add fuel 
to a cool engine only.
Do not fill fuel tank indoors.  Keep open flames, sparks, 12. 
smoking materials and other sources of combustion 
away from fuel.
Do  not  operate  machine  without  shields  in  place.  13. 
Failure to do so may cause serious injury or death.
Keep  all  guards,  deflectors,  and  shields  in  good 14. 
working condition.
Before inspecting or servicing any part of this machine, 15. 
shut off the machine and make sure all moving parts 
have come to a complete stop. Disconnect the battery 
and remove the ignition key where applicable.
Check that all screws, nuts, bolts, and other fasteners 16. 
are secured, tightened and in proper working condition 
before starting the machine.
1.5   MAINTENANCE AND STORAGE SAFETY
1.6   BATTERY SAFETY
Before  inspecting,  servicing,  storing,  or  changing 1. 
an  accessory,  shut  off  the  machine  and  make  sure 
all  moving  parts  have  come  to  a  complete  stop. 
Disconnect  the  battery  and  remove  the  ignition  key 
where applicable.
Replace  any  missing  or  unreadable  safety  decals.  2. 
Refer to the safety decal section for part numbers.
Allow machine to cool before storing in an enclosure.3. 
Store the machine out of reach of children and where 4. 
fuel vapors will not reach an open flame or spark.
Never  store  this  machine  with  fuel  in  the  fuel  tank 5. 
inside a building where fumes may be ignited by an 
open flame or spark.  Ignition sources can be hot water 
and space heaters, furnaces, clothes dryers, stoves, 
electric motors, etc.
Drain the fuel and dispose of it in a safe manner for 6. 
storage periods of three months or more.
Improper use and care of the battery on electric start models 
can result in serious personal injury or property damage.  
Always observe the following safety precautions.
Poison/Danger  -  Causes  Severe  Burns.  The  battery 
contains  sulfuric  acid.   Avoid  contact  with  skin,  eyes  or 
clothing.  Keep out of reach of children.
ANTIDOTE-External Contact:  Flush immediately •
with water.
ANTIDOTE-Internal:  Drink a large amount of water •
or milk.  Follow with milk of magnesia, beaten egg 
or vegetable oil. Call a physician immediately. 
ANTIDOTE-Eye Contact:  Flush with water for 15 •
minutes. Get prompt medical attention.
The battery produces explosive gases.  Keep sparks, 1. 
flame or cigarettes away.  Ventilate area when charging 
battery.   Always  wear  safety  goggles  when  working 
near battery.
The battery contains toxic materials.  Do not damage 2. 
battery  case.    If  case  is  broken  or  damaged,  avoid 
contact with battery contents.
Neutralize  acid  spills  with  a  baking  soda  and  water 3. 
solution.  Properly dispose of a damaged or worn-out 
battery.  Check with local authorities for proper disposal 
methods.
Do not short circuit battery. Severe fumes and fire can 4. 
result.
Before  working  with  electrical  wires  or  components, 5. 
disconnect  battery  ground  (negative)  cable  first.  
Disconnect positive cable second.  Reverse this order 
when reconnecting battery cables.