Need help?Do you have a question about the Ecoflam BLU 170 and is the answer not in the manual?
Details on control boxes for burner installation and operation.
Information system for Satronic DMG 972 control, including fault codes.
Flash codes indicating faults for DLG 976 control system.
Flash codes indicating faults for DMG 972 control system.
Procedure for adjusting gas flow rate at ignition for specific burner models.
Procedure to adjust the gas pressure governor.
Procedure for adjusting gas flow rate on MB-DLE single-stage version.
Procedure for adjusting gas flow rate on MB-ZRDLE two-stage version.
Procedure to adjust the fast opening hydraulic brake.
Notes on adjusting gas solenoid valves by authorized personnel.
Procedure to set the gas minimum pressure switch.
Procedure to adjust the air pressure switch for correct operation.
Procedure to adjust inlet air flow for ON-OFF versions.
How to set the firing head for optimal combustion parameters.
Instructions for removing the blast tube from the burner.
Table detailing movable ring positions based on power output.
Procedure to convert burner from Natural Gas to LPG and vice-versa.
Diagram showing the correct position of electrodes.
Periodic checks to be performed annually by authorized technicians.
Guidance on common burner startup and operation faults.
To Next Page
General