Replace disinfectant bottle
Replace the disinfectant bottle:
In Work process
NOTICE!
To ensure uninterrupted supply to the system, you should replace the 500
or 1000 ml disinfectant bottles in good time and keep them in reserve if
necessary
.
Bottle change
1.
Open dosing dispenser with key (
Ä
Chapter 3 ‘Scope of delivery’ on page 17).
2. Pull the dosing hose (pos. 1), coming from the pump, out of the bottle.
3. Remove the cap of the new bottle (pos. 4).
4. Guide the new bottle over the suction hose from below and ensure that the hose
hangs centrally in the bottle and is not kinked.
5. Place the bottle neck over the guide spigot
(on the underside of the sensor carrier plate).
6. Lift the bottle stopper (pos. 5) so that the bottle is clamped.
7. Remove the key.
8. Close dosing dispenser.
Service
35 MAN048961, Rev. 2-09.2020
To Next Page
Loading...