Back to previous screen (usually assigned to SK #1)
Exit out of programming mode, back to main idle screen (customer’s screen)
Edit mode (note the use of a pencil)
Test a component (Formula Select or MSI or IO module for their revision of installed
software)
Edit a step (note the use of a pencil)
Summary: list the information (in a formula)
More: more information is available
Edit product. (note the use of a pencil)
Reset this selection ONLY
Reset all (back to new factory settings)
No (to confirm a selection)
Yes (to confirm a selection)
On: activate a component (pump or valve)
Off: de-activate a component (pump or valve)
Test the integrity of the pick-up probe and its wiring in a full container. The float switch
inside the probe should be in the up position.
Test the integrity of the pick-up probe and its wiring in an empty container (or outside of
a container). The float switch inside the probe should be in the down position.
To Next Page
Loading...
