55
3.0 Start-Up and Operation
The following procedures take you through a step-by-step routine to verify the AQUANOMIC EU dispenser has been
installed and functions properly. Before proceeding with this section, the following items should be completed:
✓ Wash formulae programmed into Condor Controller.
✓ Washer chemical request signals are programmed to match steps in Condor Controller.
✓ Mount Condor Controller and Pump Cabinet.
✓ Mount MSI and Formula Select modules.
o Assign each a unique address (#1-3).
o Daisy chain all modules together.
✓ Make tubing and electrical connections to and from Pump Cabinet.
✓ Connect Pump Cabinet to appropriate power source.
Upon dispenser start-up, the Condor main screen will read “Please wait…” while the system is connecting and syncing to all
daisy chained modules. Do NOT press any buttons while this message is displayed on-screen.
3.1 Product/Wash Signal Check
This check is done without products. Dispensing products will be done after the hydraulics and washer valve operation has been
verified.
1. Select a formula and run the laundry machine through a complete cycle.
2. The pump should run as programmed (pre flush and post flush). The screen will display when a dispense is
running. Refer to section 1.2 Customer Screens.
3. If dispenser does not run as programmed, check the signal LEDs on the Machine Interface. If they do not light at
the time the washer should be calling for product, then re-check the trigger wiring.
3.2 Hydraulics Check
1. Enter the TM screens on the Condor Controller by holding center key for 5 seconds followed by the password.
(Up, Down, Left, Right, and enter (center square)).
2. Use down arrow key until “Diagnostics” is highlighted. Press enter.
3. Select “WE Components” and Washer number.
4. Select “Main Water Flush” and perform a 30 second main water flush to each washing machine to ensure proper
valve wiring and operation. During each diagnostic flush:
• Check for leaks.
• Check water pressure at the regulator gauge – adjust if needed.
5. Write down date of installation on Maintenance Service Label on inside of front cover.
3.3 Product Dispense Check
Wear proper PPE when first starting up the system with products.
If any problems are encountered, consult Section 4.0 Troubleshooting
To Next Page
Loading...
