5.2.2.2 Switching the ‘EcoAdd
’ pump on and off
The pump is switched on the ‘ON/OFF switch’ .
After switching on, the pump is ready for operation.
ð
On startup, the pump shows the info screen with the display of hte determined
technical data of the connected components.
5.2.3 Select the operating mode for the metering pump
n Manual mode (preset at the factory)
n Automatic mode
5.2.3.1 Activate manual mode with the EcoAdd metering pump
1. Open the main menu.
2. [Operating mode] selection.
ð
Screen switches to the selection level [Operating mode].
3. ‘Select Manual
’:
4.
Save the setting by pressing the button
ð
The screen switches to the overview: [Main menu].
In manual mode, you can set the litre output of the pump manually.
5.2.3.2
Activate manual mode for the EcoPro metering pump
Press the "Test" button on the pump control panel.
5.2.3.3 Activate manual pump mode via OEM connection box
In a dosing station with OEM connection box, manual pump operation is only possible if
the pump is connected to the external main controller
.
1. T
o activate manual pump operation, press and hold the "Test" button on the
OEM connection box.
ð
The metering pump will start up.
2. T
o deactivate manual pump operation, release the "Test" button on the
OEM connection box.
ð
The metering pump will be paused.
5.2.3.4 Activate automatic mode with the EcoAdd metering pump
You can select the following modes:
n Pulse
n Current
n T
imer
Comissioning and operation
46417101656 Rev. 01-10.2019
To Next Page
Loading...
