4 Setup, assembly and installation
Personnel:
n
Mechanic
n
Qualified electrician
n
Specialist
Protective equipment:
n
Protective eyewear
n
Protective gloves
n
Safety shoes
WARNING!
Installation and assembly must only be carried out by authorised and
trained personnel in accordance with the general guidelines in force,
and the installation regulations in force on site must be observed.
Always install this machine/system above the maximum product level in the
storage container!
DANGER!
If the system is not observed during operation, the product may escape.
It is important that you observe the safety guidelines given in
(
Ä
‘Requirements for system components provided by the operator’
on page 27).
NOTICE!
Material damage by using incorrect tools!
Material damage may arise by using incorrect tools during assembly
,
maintenance or troubleshooting. Only use the correct tools.
The most important components of the basic equipment are factory-fitted in the metering
station and are also tested there.
There are some components that are not factory assembled and tested, and therefore
must be installed and checked when the metering station console is integrated into the
overall system. The components are installed in the overall system in accordance with the
flow diagram and operating instructions for the components.
Setup, assembly and installation
35 417101656 Rev. 01-10.2019
To Next Page
Loading...
Need help?
General
