Ecolab GEOCENTER - Page 4

iv
7.0 SYSTEM OPERATING FEATURES ............................................................... 11
7.1 Power Lights ............................................................................................
11
7.2 Feed Light ...............................................................................................
11
7.3 100% Light ..............................................................................................
11
7.4 Temperature Compensation ....................................................................
11
7.5 Optional Jumper Settings ........................................................................
11
8.0 SERVICE ........................................................................................................ 12
8.1 Regular Inspection .................................................................................
12
8.2 Squeeze Tube Replacement Instructions ...............................................
12
9.0 TROUBLESHOOTING .................................................................................... 13
9.1 Unit does not operate - No Power Light. ................................................
13
9.2 Unit does not feed - Power Light and Feed Light on. .............................
13
9.3 Unit does not feed - Power Light on, Feed Light not on. ........................
14
9.4 Feeds continuously - Feed Light not on. ................................................
14
9.5 Feeds continuously - Feed Light on. ......................................................
14
9.6 Fluctuating titration. ................................................................................
15
9.7 Excessive detergent consumption. .........................................................
15
9.8 Rinse Injector does not activate. ............................................................
15
9.9 Rinse Injector runs, no rinse additive being injected. .............................
16
9.10 Rinse Injector runs continuously ............................................................
16
9.11 Rinse Injector will not prime. ..................................................................
16
9.12 Excessive squeeze tube wear. ...............................................................
16
9.13 Fuse on Speed Rinse P.C. board is blowing repeatedly. ........................
16
10.0 REPLACEMENT PARTS ................................................................................
17
11.0 OPTIONAL PRESSURE SWITCH INSTALLATION ....................................... 18