Econ 7907EX User Manual

Installation & Operation Manual Proven Quality since 1892
ECON actuator Fig. 7907, type ELA80 – 3000 www.eriks.com
Rev.23 – August, 2023 25
Select Input
Signal Switch
B) Selecting Input Signal
Depending on the system environment a suitable input signal can be selected by adjusting the
SW7 DIP-switches as follows:
Notes:
- 4-20mA is the standard factory setting for the input signal of this PCU.
- ZERO SWITCH (SW7.3). Same application of input and output signals.
C) Selecting Output Signal
Depending the system environment a suitable output (feedback) signal can be selected by adj
usting the SW8 DIP-switches as follows:
Note: 4-20mA is the standard factory setting for the output signal of this PCU.
CAUTION: “(1) Selection of input signal” ZERO SWITCH (SW7.3) Usage Notes
Select Output Signal
By Dip Switch

Econ 7907EX Specifications

General

Brand	Econ
Model	7907EX
Category	Controller
Language	English